1. Home
  2. Question and Answer
  3. Houseplants
  4. Garden Articles
  5. Most Popular Plants
  6. Plant Nutrition
-

Adding Sprinkler Heads to PVC Pipe Using Saddle Tees

A homeowner wants to add sprinkler heads to an existing PVC shrub irrigation line. Home Depot no longer carries the old “snap-on tee” fittings that were glued and drilled. Better Solution: Brass Saddle Tees Brass saddle

-

Watering New Sod: Frequency and Preparation

New sod needs daily watering—enough to soak the soil beneath until it’s almost too wet to walk on. Frequency depends on temperature, wind, and soil type. Multiple short soakings are better than one long run to prevent ru

-

Ground Cover Solutions for a Wet, Clay Backyard

A small Georgia backyard (20 x 8) has terrible drainage—water from Saturday still hasn’t drained by Monday. Half is flower bed; the other half needs ground cover that tolerates wet clay. Recommended Ground Cover Pachysa

-

Finding Affordable Irrigation Supplies Online

Looking for an online irrigation supplier cheaper than local dealers. Wholesale Options Most metropolitan areas have wholesale irrigation suppliers (e.g., Ewing Irrigation in the western U.S., John Deere Landscapes nati

-

Troubleshooting an Old Irrigation Pump Motor That Won’t Run

A 15–20 year old irrigation pump in South Florida doesn’t start. The timer ticks (fuses good), but the motor is silent—no hum. Contacts were cleaned with sandpaper; still nothing. The pump is likely centrifugal. Diagnos

-

Building a French Drain to Redirect Yard Water

A homeowner in Southern Maine has standing water in two backyard spots after heavy rain. The yard slopes slightly from neighboring properties and the driveway. A follow-up asks about running a French drain 75 feet with a

-

Diagnosing Pressure Drop in a Deep Well Irrigation System

A 310 deep well with a submersible pump at 163 feeds a zoned irrigation system directly (no tank). Spring startup pressure was 50 PSI; six weeks later it’s 40 PSI across all zones. The pump is 14 years old. The owner sus

-

Shallow Well Pump Loses Prime Unless Plug Is Removed

A 24 deep shallow well with an 18 water table uses a 2 HP pump with 1-1/4 drive pipe and 1 outlet. After priming, it works well, but after shutdown it only re-primes if the plug on the discharge tee is removed for ~15 se

-

Draining a High Water Table on a Large Wooded Lot

A 300 x 1000 wooded property has a water table 0–12 inches below the surface, causing persistent surface water after heavy rain. The owner asks if a single trench the length of the property draining to a low area will so

-

Why a Drip Conversion Causes a Valve to Not Close Fully

After replacing bubbler heads with 8-way drip emitters on 1/4 tubing, a Rain Bird APAS 3/4 anti-siphon valve won’t shut off completely. Water seeps from the anti-siphon vent and the drip heads when the zone is off. Clean

-

Removing a Stuck Electric Motor from a Gould Irrigation Pump

A homeowner unbolted a burned-out electric motor from a Gould irrigation pump but cannot separate the motor from the pump housing. No latch pin is visible; corrosion is the likely culprit. Steps to Free the Motor Tap t

-

Fixing a Well Pump That Overheats and Only Waters One Zone

An irrigation system with a well pump has two symptoms: only zone 1 gets watered, and the pump takes 2–4 minutes to start delivering water after a restart. The problem began after a sprinkler head and some piping were re

-

Preventing Well Pump Short Cycling with a Drip Irrigation Zone

A Toro blue stripe drip system on a separate zone causes the well pump to cycle on and off rapidly. The lawn zones work fine, but the low flow of the drip system makes the pump repressurize quickly and repeat, risking pu

-

Fixing a Leaking Drip Zone and Flooded Valve Box

A new sprinkler system in western South Dakota has two issues: a persistent hissing sound from the drip line even when the system is off, and a green valve control box completely submerged in water despite dry weather.

-

Troubleshooting Low Pressure in a Shallow Well Irrigation System

A homeowner noticed their shallow well, installed four years ago for lawn and flower bed irrigation, had gradually lost pressure. Originally able to run seven sprinkler heads, the system now only supports three. The well

-

The Role of a Pressure Tank in a Large Irrigation Pump System

The Role of a Pressure Tank in a Large Irrigation Pump System In a large irrigation system with a 15 HP pump drawing from a pond, a pressure tank and switch are installed even though the pump is controlled by a time cloc

-

Sizing a Lake Pump for Residential Lawn Irrigation via Garden Hose

Sizing a Lake Pump for Residential Lawn Irrigation via Garden Hose Pumping from a lake to a single sprinkler via garden hose is a low-demand application. A 3/4 HP pump is typically sufficient, but proper electrical and p

-

Troubleshooting Lake Pump Suction Line Issues: Prime Loss and Friction Loss

Troubleshooting Lake Pump Suction Line Issues: Prime Loss and Friction Loss A 2 HP lake pump with a long, complex suction line may lose prime or suffer from excessive friction loss. This case involves 196 feet of 2-inch

-

Designing a High-Performance Irrigation System: Component Selection and Water Supply Strategy

Designing a High-Performance Irrigation System: Component Selection and Water Supply Strategy For a 1/3-acre property in Minnesota, selecting the right components and ensuring adequate water supply are critical. This art

-

Comparing Irrigation Brands: Hunter vs. Toro for Reliability and Performance

Comparing Irrigation Brands: Hunter vs. Toro for Reliability and Performance Choosing between major irrigation brands impacts long-term maintenance and system performance. Based on extensive field experience, this articl

Total 1773 -Article  FirstPage PreviousPage NextPage LastPage CurrentPage:2/89  20-Article/Page Goto:1 2 3 4 5 6 7 8

Copyright © www.100flowers.win Botanic Garden All Rights Reserved