1. Home
  2. Question and Answer
  3. Houseplants
  4. Garden Articles
  5. Most Popular Plants
  6. Plant Nutrition

Sprinkler Station Not Working: James Hardie HHA-11272 Controller

One Zone Fails to Activate on Schedule, Works in Manual Mode

A single station on a James Hardie irrigation system (HHA-11272 board) does not run during programmed cycles, though all stations work in manual mode. Power to the board is confirmed.

Troubleshooting Checklist

  1. Inspect wiring: Check connections at the controller and valve for corrosion, loose wires, or water damage. Ensure waterproof splices.
  2. Verify flow control: The valve's flow control handle should be open about halfway.
  3. Review programming: Confirm the station has a run time, a start time, and watering days assigned in the active program.
  4. Reset controller: Disconnect AC power and backup battery for 5 minutes, then reprogram.
  5. Test controller output: With a multimeter, measure AC voltage (22–26 VAC) between the common terminal and the suspect station terminal while the station is supposed to be running. No voltage indicates a controller fault.

If voltage is present at the controller but the valve doesn't operate, the valve or its solenoid is likely faulty. If no voltage appears, the controller may need replacement.

Copyright © www.100flowers.win Botanic Garden All Rights Reserved