Adjusting Toro Vision 1 Rotor Sprinkler Head Arc

How to Set the Rotation Arc on a Toro Vision 1 Rotor Head

A user can adjust spray distance with an Allen key but cannot figure out how to limit the head's rotation to avoid watering the street. There's a screwdriver slot below the spray adjustment.

Adjustment Procedure for Toro Rotor Heads

1. Find the fixed left stop: Rotate the turret clockwise until it stops, then turn it counterclockwise to the left stop. This left edge is fixed.
2. Set the left stop position: Physically rotate the entire head body so the left stop aims where you want the spray to start.
3. Adjust the right stop (arc): Insert a screwdriver into the adjustment slot.
   • Turn counterclockwise to decrease the arc (less rotation).
   • Turn clockwise to increase the arc (more rotation).
4. Test: Run the zone and observe. Fine-tune as needed.

If the head is not a rotor (e.g., a spray head), visit toro.com for model-specific instructions.