New install, shows “Mv” only (no “Fuse”). Intake screen not installed; pressure low last run.
“Mv” = master valve circuit fault. With a pump, you need a 24 V pump‑start relay. Installer must check master valve/pump start circuit. Clogged intake/impeller can overload pump start, causing Mv error.
Hardie Total Control Error Code #1: Short on Valve 1 Circuit
Irritrol SR1 Pump Relay Troubleshooting: Voltage Drop Diagnosis
Sprinkler Pump Trips Breaker: Is a $1,400 Motor Replacement Justified?
Sprinkler Pump Runs but No Pressure – Common Causes
Toro Greenkeeper 212 Water Drop Symbol: Rain Sensor or Controller Fault
Pump Rapid Cycles Only on Zone 3 – Adjust Pressure Switch or Increase Flow
Toro Extra Timer & Hunter PSR-22 Relay: EMF Interference Myth
Rain Bird Controller On But Pump Not Starting: Test PS/MV Terminal Voltage
New Homeowner: Toro Greenkeeper System – What to Do with Valves in the Box?
Toro Vision II: One Zone Shows 24V Constantly But Won't Water
Rain Bird Controller: New Unit Doesn’t Start Pump – Wiring or Pump Issue
Diagnosing Recurring Pump Prime Loss After Check Valve Replacement
Eliminating Pump by Switching to Rotor Heads on Municipal Supply
Copyright © www.100flowers.win Botanic Garden All Rights Reserved