On a Hardie HR-6100, all five zones work manually, but in Auto mode only the first zone activates and won't shut off. Skipping to zone 2 produces the same issue. A dead battery and power outage preceded the problem.
De-energize the controller: remove the battery, disconnect power for 30+ seconds, then restore power and reprogram—without the battery initially. Test automatic operation. If it works, reinstall the battery. If the problem persists, the controller likely needs replacement.
Hardie RD-1200 Battery Drain: Replace Panel, Not Whole Controller
Hardie Slim Line Controller Dim/Broken Display—Replacement Needed
Hardie Total Control TC-15B "Error - 1" After Freeze
Hardie Total Control "Short" Error – Controller or Solenoid #6
Hardie HR-6100 Zone No Water – Diaphragm Likely Faulty
Hardie 6-Station Indoor Controller Runs 15 Seconds Instead of 15 Minutes
KwikDial Battery Symbol Flashing: Internal Memory Failure
Irritrol Rain Dial RD1200 Button Failures – Panel Replacement
Hardie HHA-11272 Replacement: Rain Dial Panel Swap
Hardie Rain Dial 1993: Zones 6 & 7 Run Together—Crossed Wire or Controller
Hardie 6100 Zone 2 Stays On: Controller Port or Valve Fault?
Replacing a Heat-Damaged Hardie RD-600 Sprinkler Controller in Arizona
James Hardie HR-6100 No Power: Transformer Replacement Guide
Copyright © www.100flowers.win Botanic Garden All Rights Reserved