Botanic Garden >> Gardening > >> Question and Answer >> Irrigation

Hunter Pro-C Tripping Breaker: Reset First, Then Replace If Needed

Pro-C tripping house breaker — do master reset (hold PRG, press reset). If still trips, replace controller. But Pro-C is good — consider identical replacement (same wiring, mounts). We replace more Rain Birds than Hunters.

Irrigation: Hunter Pro-C Programming: Start Times Are for Programs, Not Individual Stations; Hunter Pro-C Shows Running But No Water: Test Controller Voltage Output; Hunter EC400 Garbled Display: LCD or Microprocessor Failure — Replace Controller; Hunter Pro‑C Runs at Unscheduled Times – Clear Programs B and C; Hunter EC Controller Stations 1&2 Not Working: Power Surge Damage; Diagnosing Pulsing Zone on Hunter Pro-C Controller; Hunter SRC "No AC" Display—Power Supply Issue; Hunter Pro-C Module Recognition Issue: Secure Expansion Modules Properly; Hunter Pro-C Suddenly Shows Only 3 Stations; Hunter Pro-C "Err" on Zone 3: Solenoid vs. Wiring Diagnosis

Garden Articles

Hunter SRC Plus Two Zones Not Working: Electrical Troubleshooting

Hunter SRC Plus Unreliable After 6 Years: Replace Controller

Hunter Controller Zone Running Too Long: Programming Error or Hardware Failure?

Hunter EC 'NO AC' Error After Siding Work: Transformer or Controller Fault?

Recurring Hunter XC Controller Failures: Wiring Short or Solenoid Issue?

Hunter Pro-C Multiple Start Times Causing Repeated Cycles: How to Clear Extra Start Times

Hunter XC Controller No Display After Power Outage: Reset and Power Checks

Plants

Hunter XC Controller Stuck on Wrong Time – Reset Procedure

Troubleshooting Hunter EC-400 Controller Time Setting Issues

Hunter Control Won't Start Well Pump – Check Pump Start Relay Circuit

Troubleshooting Hunter Pro-C Module Failures After a Storm

Hunter ICC "NO AC" With Good Transformer Voltage: Board Failure

Converting a Toro Hydraulic Controller to Electric

Hunter EC Controller Stuck on "SYSTEM OFF": Reset Procedure