Imperial Valet 11-Station Timer Active but No Water: Verify Supply and Controller Output

Timer Cycles but No Sprinklers Activate

Ensure the main irrigation supply valve is open.
Remove bottom panel of timer, access terminal strip.
With volt/ohm meter, test voltage between common (C) and station 1 while station 1 is active. Should read 22–26 VAC.
If voltage present → field wiring or valve issue. If absent → timer fault.

Irrigation: Troubleshooting Sprinkler System Error Codes After Plumbing Work; Imperial 11‑Station Timer Trips Reset – Master Valve Solenoid or Other Zone?; Imperial Valvet 11‑Station Timer Manual – Setting Instructions; Replacing 20-Year-Old EZ-1 Timer (Rain Bird ESP Series Recommended); Rain Bird 600: Manual Mode Zone 2 Opens Zone 1 Instead; Hunter Pro-C Missing Station? Reseat the Expansion Module; Sprinkler Timer Motor Replacement—DIY Procedure; Rain Bird ESP-6SI Auto Program Skips Stations 4 and 5: Verify Programming Steps; Orbit Timer On/Off Flashing: Shorted Solenoids; Hardie Total Control 15-Station: "Short" Error Message

Garden Articles

Plants