5 zones. Zone 5 (backyard, lower level) stopped working after landscaping above. Box says on but no water. Other zones work.
"Since some work was done in the area, there could be a few things to check. Make sure that the control valve for that station has the flow control open about halfway. Then check to see if the wiring connections are good. Hopefully the control wires were not damaged."
Landscaping equipment often severs or nicks valve wires. Flow control may have been accidentally closed. Start with these two before digging for pipe damage.
Rain Bird RC-7Bi Stuck on Zone 1: Advance Motor or Switch Failure
Troubleshooting a “Possessed” Zone Valve That Runs With Every Station
Richdel 446PR Hybrid: Zone 2 Runs Continuously Even in Off Position
Controller Outputs 24V Constantly on One Zone: Workaround or Replace
Diagnosing a Shorted Solenoid on Zone 2 (Hunter SRC+ System)
RC-7BI Controller Single Zone Operation: Stuck Valve Diagnosis
K-Rain Valves All Open Simultaneously: Wiring and Valve Configuration Errors
JH 4000 Controller Blinking Display: Sign of Impending Failure
Toro Green Keeper Zone 3 Inactive: Test Solenoid Voltage and Valve Type
Hardie Controller Flashes, Won't Run – 15 Years Old, Replace
Sprinkler Valves Buried Under Concrete Patio: Must Relocate
Low Pressure on Two Zones: Pump or System Issue?
Locating Buried Control Valves: Wire Tracer or Systematic Probing
Copyright © www.100flowers.win Botanic Garden All Rights Reserved