Irritrol KwikDial Blinking Display: Reset or Replace Panel

Blinking display with functional manual operation = classic KwikDial panel failure after years of service.

Try Reset

Momentarily bridge the "RESET" contacts on the back of the panel with a screwdriver. Reprogram if it works.

If Reset Fails

• Panel (display board) has a failed component.
• Buy replacement panel only — not whole controller.
• Check Irritrol repair: 800-634-8873 (low-cost, 48–72 hr).

Note

Internal fuse exists but requires panel hinge-out to access. Usually not the issue.