Old Hardie has one wire per zone; Rain Bird instructions show two wires per zone plus common.
Each valve has two wires: a unique hot and a shared common. The Hardie’s “C” terminal is the common. Label each wire (1,2,… and C) and connect to same numbers on Rain Bird.
Rain Bird 7RCBI Stops at Zone 1 – Discontinued, Replace with ESP
Diagnosing a Shorted Solenoid on Zone 2 (Hunter SRC+ System)
Hardie Controller Manual Station Error: Replace Panel or Upgrade to Rain Dial
Hardie 446PR Display Garbled: Reset or Replace
Hardie UltraFlow 2" Valves Won't Close—Solenoid then Diaphragm
Rain Bird SST-400i Zone 3 Error and Simultaneous Operation: Wiring Cross-Check
Designing a 1-Acre Irrigation System from a Point Well: Mainline Layout and Wiring
Rain Bird ESP-12LX: Schedule One Zone Weekly, Others by Custom Days
Rain Bird RC-7A Station Wheel Stopped: Motor or Switch Failed
Hardie Controller Runs Continuously: Valve or Controller Fault?
Identifying an Old Hardie 1-Inch Valve (25+ Years) for Diaphragm Replacement
Rain Bird ESP-6 Shows "8888": Controller Likely Dead, Replace with ESP-Modular
Hardie HR6200 Fuse Holder Replacement: Contact Irritrol (Toro)
Copyright © www.100flowers.win Botanic Garden All Rights Reserved