A Toro Extra automatic sprinkler controller runs zones continuously past their scheduled times, toggling through all four zones indefinitely until manually shut off. The owner has verified programming per the manual twice.
Multiple start times accidentally programmed is the most frequent cause. Check all start time slots (often labeled Start Time 1, 2, 3, etc.) to ensure only one is set for your desired 3 AM start.
If programming is correct but the controller cycles endlessly, the timer's internal logic board may have failed. After 10+ years, replacement is often more cost-effective than repair. Modern controllers offer better features, WiFi connectivity, and water-saving algorithms.
Toro 6‑Zone Lake‑Fed System: Multiple Zones Fail After Dewinterization
Toro 4‑Zone Hydraulic System: Two Stations Don’t Water – Valve Problem
Starting a Toro Vision 1 System for the Season: Spring Start-Up Procedure
Toro Vision 1 Transformer Wiring: Terminals 0, 15, 24 After Wire Disconnection
Toro Vision 1 System Requires Manual Bleeding of Master Valve
Toro Vision Controller (1990): Testing and Operation Guide
Toro Hydraulic System Parts: Try Commercial Suppliers or Go Electronic
Toro Ecxtra Timer: Auto Mode Fails — Check Rain Sensor Jumper & Solenoid Shorts
Toro Green Keeper Irrigation Manual Download
Toro Zone 3 Failure: Controller Voltage Test After Valve and Pump Replacement
Toro Greenkeeper 212: Zone Won't Shut Off
Calculating GPM for Sprinkler System Design
Simple Battery-Timer Drip System for Potted Plants on a Hose Bib
Choosing an RO System for Hard Well Water: Hydro-Logic Merlin Review
Copyright © www.100flowers.win Botanic Garden All Rights Reserved